Professional Metal Roof Ridge Cap Roll Forming Machine / Step Flashing Machine

Product Description

Step flashing machine, roofing ridge cap forming machine

Quick Detail:

1. Thickness : 0.4-0.6mm
2. Material : pre-painted steel
3. Input width :520mm
4. Material weight : 3MT
5. Coil inner diameter : 480mm
6. Driven way: by driven motor
7. Cutting way: no waste cut
8. Cutting tolerance : ±1mm

Machine list:

1. 3T*600mm hydraulic un-coiler
2. Roll former
3. Hydraulic cutting device
4. Run out table
5. Siemens PLC and IOP/ touch screen, Schneider brand inverter

Description/Technical Parameter details of complete line:

• 3TX600mm Hydraulic Un-Coiler

Hydraulic system for expansion coil-inner-hole with 4 palms

Pump power=1.5KW

Load capacity=3 Ton

Coil Inner – diameter =451-530 mm

Coiler Width=Max. 600 mm

• Roll forming machine with cutting details as below table :

• PLC Control System

Siemens brand PLC and touch screen, Schneider/ Shihlin/ Delta brand Inverter, Omron encoder

Cut-to-length tolerance≤±1mm

Control Voltage 24V

• Product Rack Un-powered, 3 units

Brief Introduction:

There are different roof flashing roll forming machines based on different technical requirements on the final products, however, in the market people most of time use three kinds of roof ridge cap roll forming machines. Roof ridge caps with pressed STEPs, Roof ridge cap without steps, and V shaped roof flashing without STEPs. It has to be pointed out that a roof ridge caps without STEPS sometimes can be used both as roof ridge caps and as roof valley flashings. In addition, there is a similar machine, Glazed Tile Roll Forming Machine.

This roof ridge caps without pressed steps design

Profile Drawing/Layout/Equipment reference pictures: